10%精草铵膦铵盐SL的UPLC-MS/MS分析方法

[目的]建立10%精草铵膦铵盐可溶液剂的超高效液相色谱-三重四级杆质谱(UPLC-MS/MS)定量分析方法。[方法]使用Zorbax SB-C18色谱柱,流动相为0.1%甲酸水-乙腈,流速为0.3 m L/min,在多反应监测(MRM)模式下进行正离子扫描,测定样品中精草铵膦的含量。[结果]在0.005~0.5 mg/L的质量浓度范围内,方法线性相关性良好,相关系数R2为0.9996,标准偏差为0.056,变异系数为0.56%,加标回收率在97.82%~100.84%之间。[结论]该方法操作简便、准确度和精密度高,适用于10%精草铵膦铵盐可溶液剂的定量分析。     

Mathematical law of size effect on the flexural property of ceramics

Brittle materials generally exhibit size effects, and the mechanical properties of these materials degrade significantly with an increase in size. However, the mathematical law governing the attenuation degree of mechanical properties with the increase in size is still unknown. In this study, maximum loads of differently sized ceramic test strips were subjected to three point bending tests under two working conditions of equal spans and span amplifications, respectively. Subsequently, the theoretical maximum loads of materials were calculated using the finite element method (FEM). By calculating the difference between the calculated values and the actual maximum loads, the attenuation of mechanical properties of ceramic samples were observed. The results show that the theoretical mechanical properties and the performance attenuation caused by the size effect tend to increase according to the following equation: y=ax³+bx²+cx+d. Therefore, mechanical properties and performance attenuation of any sample exhibiting a size within the experimental range can be predicted by a mathematical law, which was obtained through mechanical tests results of four samples with different sizes. The obtained mathematical law holds great significance for predicting the mechanical properties of materials under size effects.     

Novel Bi4O5Br2/MnxZn1-xFe2O4 magnetic composite with an enhanced photodegradation activity and excellent recyclability

Bi₄O₅Br₂/Mn_xZn_1-xFe₂O₄ nanocomposites with impressive photocatalytic and recyclability properties were synthesised using a microemulsion method. In addition to the photocatalytic effect, the crystal structure and morphology, photoelectrochemical characteristics, magnetic effect and photocatalytic mechanism of Bi₄O₅Br₂/Mn_xZn_1-xFe₂O₄ were also investigated. As the best sample, the removal rate of the Bi₄O₅Br₂/Mn_xZn_1-xFe₂O₄ photocatalyst with 7.5 wt% Mn_xZn_1-xFe₂O₄ to rhodamine B (RhB) reached up to 99.4% within 60 min. The enhanced photocatalyst activity was mainly attributed to the type-II heterojunction formed between Bi₄O₅Br₂ and Mn_xZn_1-xFe₂O₄, which not only optimised the energy band structure, but also led to the building of an interior electromagnetic field within the Bi₄O₅Br₂/Mn_xZn_1-xFe₂O₄ heterojunction. Meanwhile, the constantly producing and migrating h⁺ and ·O₂^? were the main active components. In particular, the results of the saturation magnetization tests and magnetic recovery experiments revealed that the magnetic composite photocatalyst can be recovered effectively. The results of the removal rate of RhB remaining at 85.2% after five uses reflected the advantages of the stability of the Bi₄O₅Br₂/Mn_xZn_1-xFe₂O₄ photocatalyst. In brief, this paper presented an original idea to develop a novel composite magnetic photocatalyst and research the enhancement mechanism of photocatalysis.     

基于CFD⁃DEM的水下切粒装置水室内颗粒流动过程数值模拟

基于CFD?DEM耦合方法，研究了颗粒在水室内的流动状态，分析了不同刀盘转速、粒子水通入量和水室出口角度对造粒过程的影响，发现提高刀盘转速、增加粒子水通入量和水室出口倾斜一定的角度都有利于水室内颗粒的排出。进一步研究了颗粒与碎屑在水室内的流动，发现在水室出口处二者的流动基本呈现出一定的分离角度。     

大豆蛋白纳米纤维对铁纳米颗粒的稳态化作用

为明确大豆蛋白纳米纤维的结构形成和扩宽铁强化剂的食品工业应用，以大豆分离蛋白（soy protein isolate，SPI）为原料，通过5 h的酸热处理制备纳米纤维（soy protein isolate fibrils，Fib SPI），系统研究纤维形成前后蛋白结构的变化，并进一步制备铁纳米颗粒（iron nanoparticles，Fe NPs），探究Fib SPI对铁的稳态化作用。研究结果表明：在酸热处理过程中，SPI产生大量的β-折叠结构，其与硫磺素T结合，显示出增强的荧光强度；此外，7S组分先发生降解，利于纤维成核形成，随后11S逐渐被水解，促进纤维生长；同时水解产生大量的小肽组分，提高了产物的还原力。研究进一步利用Fib SPI递送铁纳米颗粒（Fe NPs），发现与原始SPI相比，铁纳米颗粒可在Fib SPI原位形成胶体稳定的铁-大豆蛋白纳米纤维复合物（Fe FibSPI），并以Fe（II）形式存在，其对乳液体系色泽及稳定性的影响较硫酸亚铁或氯化铁小。该研究可为构建新型植物基铁强化剂递送体系提供理论和方法指导。     

Study on the influence of segmented fuel cell by grooving method and its application in oxygen starvation diagnosis

The oxygen starvation in fuel cells is an important reason for the deterioration of durability. The segmented fuel cell is a method to study the gas distribution inside the fuel cell. In order to study the influence of the grooving method on segmented fuel cell and its application in oxygen starvation diagnosis, a five-serpentine-channel three-dimensional two-phase simulation model is established by FLUENT. Through steady-state simulation, the effect of grooving method on fuel cell performance is studied. The overall performance (polarization curve) of the fuel cell drops slightly, but the current density distribution on the anode graphite plate changes greatly due to the grooves. The “current concentration” phenomenon is proposed based on the current density distribution. Through dynamic simulation, the oxygen starvation under current load mode and voltage load mode is simulated, and the “starvation coefficient” is defined as an oxygen starvation diagnostic index. In the current load mode, the “starvation coefficient” never exceed 15%, because when the oxygen starvation is severe, the simulation cannot converge or even cannot maintain, which corresponds to the voltage reversal in reality. However, in the voltage load mode, the “starvation coefficient” can reach up to 100%. The conclusions have important guiding significance for the judgment of the internal reaction uniformity of the segmented fuel cell by grooving method and provide a theoretical basis for judging whether a fuel cell is out of oxygen by segmented fuel cell.     

The effect of biomass feeding location on rice husk gasification for hydrogen production

The objective of this study is to investigate the impact of biomass feeding location on rice husk gasification for hydrogen production. By comparing the results between top-feed and bottom-feed of the feedstock of the fluidized bed biomass gasification at the reaction temperature between 600～1000 °C and ER = 0.2, 0.27, and 0.33 without steam, the optimum low heating value was increase by 2.35 kJ/g-rice husk by the top-feed to gasifier. Although the yield of hydrogen was decreased by 42% for the rice husk gasification by the top-feed operation, the yield of CO, CO2, and CH4 were highly increased, which enhancing the heating value of the effluent gas. The study results suggested the potential route of the biomass gasification at the different feeding location.     

南水北调中线总干渠藻类的生态调度

南水北调中线总干渠无在线调蓄水库,对藻类生态调度过程中出现的问题开展生态调度实现策略和实施方式研究。主要实现策略包括:划定自身的调蓄区,隔离生态调度对下游的影响;采用高效的渠池运行方式,减少生态调度时蓄量的反复调整;综合考虑安全、快速、平稳等需求,设定生态调度实施进程和方式。具体实施方式包括:将总干渠划分为流速调控区、调蓄区和正常运行区,分别实施等体积、控制蓄量和闸前常水位方式运行;将生态调度过程划分为充水阶段和泄水阶段,基于流速调控目标值、持续时长和水位降幅约束条件,确定各阶段时长和各分区的闸门群调控方案等。基于2018年3月输水工况,采用明渠一维非恒定流模型,仿真总干渠上游15个渠池的藻类生态调度过程。结果表明,生态调度可在3.5 d内完成,各渠池的平均流速由0.48 m/s增至0.93 m/s,持续时间超过2 h。在整个生态调度过程中,水位变化平稳,水位变幅符合安全阈值要求,下游渠道的正常运行未受生态调度明显影响。     

Thermal properties of hierarchical YSZ and LZO ceramic microspheres with multi-scaled voids investigated by using theoretical,experimental and simulation methods

Heat transfer within ceramic feedstock powders is still unclear, which impedes optimization of the thermal and mechanical properties of the thermal sprayed coatings. The microspheres (yttria-stabilized zirconia YSZ and lanthanum zirconate LZO) were prepared via the electro-spraying assisted phase inversion method (ESP). The thermal properties of the two ESP microspheres and a commercial hollow spherical powder (HOSP) were investigated by using theoretical, experimental, and simulation methods. Thermal conductivity of the single microsphere was estimated via a novel nest model that was derived from the Maxwell-Eucken 1 and the EMT model. Thermal conductivity of a single YSZ/LZO-ESP microsphere prepared at 1100–1200 °C was within 0.36–0.75 W/m K, which was ～ 20 % lower than that of a single YSZ-HOSP microsphere with a similar porosity. Heat flux simulation showed that high tortuosity around the multi-scaled voids of the ESP microsphere led to a more efficient decrease in thermal conductivity compared with total porosity.     

Directional separation of hydrogen-containing gas mixture by hydrate-membrane coupling method

Recovery of hydrogen (H₂) from H₂-containing gas mixtures has great significance for energy conservation, cost reduction and benefit increase. However, the common separation methods have the ubiquitous problem due to phase equilibrium principle and results in the conflict between H₂ concentration and H₂ recovery rate in the product gas. Consequently, an innovative conception of hydrate-membrane coupling approach is proposed in this work. In the separation process, hydration and membrane permeation two separation driving forces coexist to achieve the aim of strengthening mass transfer kinetics. H₂ and non-H₂ components (hydrocarbons) are synchronously and directionally selected by membrane and hydrate to improve different phase compositions. Therefore, the gas in feed side could keep relatively high two separation driving forces (H₂ fugacity and hydrocarbons fugacity). The results show that the coupling method could synchronously increase both the concentration and the recovery rate of H₂ in the product gas. At the same time, the volume and concentration of the hydrocarbons in hydrate both increases effectively. It indicates that hydrate and membrane separation methods support each other in the separation process. The hydrate-membrane coupling method fundamentally solves the issue of the decreasing driving force resulting from single separation method and phase equilibrium relationship.